District heating covers most of the residential areas and industries in the twoneighbouring Swedish municipalities Nyköping and Oxelösund. In Nyköping,Vattenfall AB Värme produces heat in a bio-fuelled CHP plant. In Oxelösund,waste heat and use of waste gases from the steel production at SSABOxelösund is the basis in the district heating system.This report examines the environmental consequences of a connection betweenthe two district heating systems. A broad system approach is used and the focusis on environmental effects in the system.A system analysis has been performed on the result of simulations of differentheat and electricity production alternatives. The alternatives simulated wereone where Vattenfall Nyköping covers the Base load in the joint district heatingsystem and two where the power plant at SSAB Oxelösund supplies the heatBase load.The conclusion in this report is that the consequences of connecting the twodistrict heating systems can be both positive and negative, depending onsystem boundaries and on the environmental focus.

This report is a Master?s Thesis performed by Andreas Adolfsson and David Jacobsson atChalmers University of Technology. The purpose of this master?s thesis is to evaluate anew method for load-shedding, the voltage controlled underfrequency load-sheddingdeveloped by ABB. This report presents a comparison between conventionalunderfrequency load-shedding and this new method for load-shedding.

The aim of this study is to evaluate whether the value of occupant load is over or under estimated when the Swedish general value for department stores, 0,5 person/m2, is used for dimensioning shopping centers. The data that was analyzed derives from seven shopping centers and one department store. A conservative method was used to calculate the occupant load factor. The analysis shows that two groups can be discerned: one group that is characterized by a lower occupant load factor that does not exceed 0,3 person/m2, and one group with a higher occupant load factor. Shopping centers with a higher occupant load factor are located centrally in large urban areas.

The aim of this study was to map the intellectual base at the Swedish School of Library and Information Science (SSLIS) at the University Collage of Borås, and to compare this intellectual base to the intellectual base of the research area Library and Information Science. This was done by analysing the citations in publications published, between the year of 2001 to the first quarter of 2006, by researchers at the institution, using the technique of author cocitation analysis. Cluster analysis and multidimensional scaling, statistical techniques that are traditional i the author cocitation analysis, formed an objective map of the intellectual base at the SSLIS. This map was then compared with three prior studies, that used the same technique to map the intellectual base of the research area. The result shows that the map of the intellectual base at the SSLIS consists of the specialities: user studies, library studies, culture/cultural policy, information retrieval, bibliometrics and information in organisations.

Syftet med denna undersökning har varit att underlätta för företaget Re-Load att presentera sin lastpall som produkt för potentiella kunder. Syftet har också varit att stötta Re-Load till att bli licenserad EUR-pall samt att successivt ersätta befintliga lastpallar och långsiktigt exekvera företagets affärsplan. Målet har varit att undersöka produkten avseende lönsamhet, miljöinverkan och hur den påverkade arbetsmiljön. Under-sökningen har genomförts med ett befintligt flöde där produkten använts och utifrån detta kunde en flödesstudie samt en komparativ produktstudie utföras med en alternativ lastpall. Med data hämtat ur detta flöde utfördes en investeringskalkylering, miljöberäkningar, subjektiva intervjuer samt dokumentation.

To be able to move around without having to think about each movement is for most people amatter of course. Todays society contributes to a life at high speed where the sparetime is oftenspend doing somekind of sport, even extreme sports which earlier only a few people wheredoing. This leads to not only good health effects but also to more injuries. One of the mostcommon injuries is the knee injury.Capio Artro Clinic is a clinic specialized in sports medicine and particulary patients with injuriesin knee, shoulder, foot, hip or elbow. They perform a great part of all the crucial ligamentsurgeries in Sweden and has therefor also a lot of patients in need for rehabilitation of the knee.During the rehabilitation the load of the injuried knee is increased in steps.

This thesis treats the extended Swedish rules regarding deduction limitations on interest. The purpose for this thesis is to investigate whether the interest deduction limitation rules have potential to protect the Swedish tax base. The thesis also assesses whether the options presented how the extended rules could look liked had been better to protect the Swedish tax base. Furthermore thin capitalizations rules have been evaluated if this is a better method to protect the Swedish tax base.In 2009 the Swedish deduction limitations rules on interest came in to force to protect the Swedish tax base. Despite these rules companies was still able to avoid Swedish tax and therefore threatened the Swedish tax base.

The purpose with this thesis work was to design and build a technical aid for installingbatteries in telecom base stations. Today that job is done manually, since there is noequipment on the market for that purpose. Installing batteries in base stations manually isa very tough job.To get ideas for possible solutions a preliminary study on existing lift aids was done.From the preliminary study the conclusion that some kind of overhead crane would besuitable for the task was drawn. After that a lift for installing batteries in base stationswas designed, built and tested. The tests show that it is possible to minimize heavy liftingwhen installing batteries in telecom base stations, at a relatively low cost.ii.

Ten colic horses and seven healthy horses were included in a prospective study aiming to evaluate acid-base disturbances in colic horses. Traditional acid-base methods and measurements of lactate were used to study prognosis and changes before, during and after surgery. Strong ion gap, anion gap and base excess were compared to evaluate their ability to predict lactate. Of the ten colic horses that went through surgery, seven survived, two were euthanised and one died. Significant differences in plasma lactate levels were seen between the group of survivals and non-survivals, p=0,000025. No differences were seen in pH and base excess between the two groups.

Combustion of fossil fuels is today the dominating source of energy. During combustion,carbon dioxide is formed. The carbon dioxide accumulates in the atmosphere,which raises the global average temperature on earth through the so called greenhouseeffect. The only way to reduce the emissions of carbon dioxide from combustionin a coal fired power plant is through carbon capture and storage (CCS).Post-combustion capture is a technology to separate carbon dioxide from the uegas after the combustion for efficient transport and storage. The steady state operationof coal fired power plants with post combustion capture has already beenthoroughly investigated on a pilot scale, however much work remains to investigatethe plants dynamic operation.

The aim of this study was to develop a load prognosis model for Uppsala district heating system to be used as a tool for heat production optimization. The methodwas to build three models for the different customer types; housing, industry andoffices and then scale them for the total system using data from Uppsala districtheating system. The heat load consists of two parts, one that is temperaturedependent and one that is dependent of the social behavior of the customers. Thetemperature part was modelled with an ARX model using an outdoor temperatureprognosis as input signal. The social behavior part was modelled using the mean ofthe social behavior from some days before and additionally by distinguishing betweenweekdays and weekends.

During the transportation of logging residues (LR) the material´s low density is a problem that results in low use of pay-load capacity. Comminution or compression of LR are possible methods to increase pay-loads. In the present thesis studied a bundling machine which was mounted on a truck chassis, and the subsequent transport and crushing. The truck bundler created bundles that were larger and longer than other bundling equipment on the market. The objectives were to determine the total time consumption and its allocation over work element and machinery, to measure dry matter (DM) content of green and brown LR-bundles.

This thesis treats the extended Swedish rules regarding deduction limitations on interest. The purpose for this thesis is to investigate whether the interest deduction limitation rules have potential to protect the Swedish tax base. The thesis also assesses whether the options presented how the extended rules could look liked had been better to protect the Swedish tax base. Furthermore thin capitalizations rules have been evaluated if this is a better method to protect the Swedish tax base.In 2009 the Swedish deduction limitations rules on interest came in to force to protect the Swedish tax base. Despite these rules companies was still able to avoid Swedish tax and therefore threatened the Swedish tax base.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.